NuShine® IIS

Graded System of polishing compounds for clad, cast or forged aluminum, nickel, stainless steel & other metal surfaces that are brand new, oxidized with use, or with atmospheric corrosion.

When using any NUVITE product, please refer to appropriate procedures and recommendations for use and equipment, or contact a NUVITE technician for more information, unique applications and special requirements.

NuShine IIS - Metal Polish for Final, Mirror Finish

NuShine® IIS

NuShine® IIA

NuShine® IIC

NuShine® IIG6

NuShine® IIF7

NuShine® IIF9

NuShine® IIF10

Final, Mirror Finish

Repolish & Light Touch Up

Oxidation Removal & Repolish

Oxidation Removal & New Metal

Heavy Oxidation & Scratch Repair

Heavy Corrosion & Surface Repair

Titanium & Select Metals

NUSHINE II - GRADED SYSTEM OF POLISHING COMPOUNDS FOR METAL SURFACES

NUSHINE® II is a metal polishing system that addresses varying surface conditions. So while procedural steps may be the same, the condition of your surface will dictate the grade with which you begin and the number of steps that will be required.

If you’re undecided where to start or how to move on, ask a NUVITE technician. Our job is to help you shine!

When using any NUVITE product, please refer to appropriate procedures and recommendations for use and equipment, or contact a NUVITE technician for more information, unique applications and special requirements.

Before beginning a polishing job ANY oils, paraffin (from smoke oils) and dirt must be removed from the surface. For best results the surface should be dry and there should be normal humidity conditions.

THE SHOULDER ZONE
Brightwork: Metal polishing rivets and seams

FOR FINAL FINISH: Before starting with NuShine® IIS use a dry, clean microfiber cloth to hand wipe the surface clean of the cutting grade polish.

1. Apply sparingly. Polish with orbital type power polishing, or by hand with cotton flannel cloth.

2. Polish until residue disappears, about 60 seconds.

3. Final finish should be a swirl-free, mirror image.

4. THE SHOULDER ZONE: Beginning top right or left of target polish area*, work back & forth, right to left within the targeted polish area. Then work same area up and down.

5. Light, but firm pressure is all that’s needed. DO NOT PRESS HARD AGAINST THE SURFACE.

6. On horizontal surfaces, pressure should be about the weight of the buffer.

7. Black residue will form over the 18”-24” target polish area. Continue moving the buffer back and forth/up and down across the surface for about 30-45 seconds. The black residue will begin to lighten and disappear.

8. Keep moving over the target polish area until black residue is gone and the clean aluminum surface shows.

Black residue may remain around the edges of the buffed area, but will be cleared as adjoining areas are buffed.

9. If there is cloudiness or scratches remain, repeat above steps until the surface is clear.

10. Repeat the above steps with each adjoining area.

11. When the wool compounding pad looks shiny with polish, fluff the nap by “spurring” with a buffing spur or a screwdriver blade held vertical against the face of the spinning pad.

QUESTIONS? NUVITE technicians have the answers 800.394.8351

Keep in mind: When using any NUVITE product, please refer to appropriate procedures and recommendations for use and equipment, or contact a NUVITE technician for more information, unique applications and special requirements. *Product dilution where applicable is determined by extent, condition & soil type.