Graded system of polishing for clad, cast or forged aluminum, nickel, stainless steel & other metal surfaces that are brand new, oxidized with use, or with atmospheric corrosion.

When using any NUVITE product, please refer to appropriate procedures and recommendations for use and equipment, or contact a NUVITE technician for more information, unique applications and special requirements.

For Repolish and Light Touch Ups: With NUSHINE® IIA before starting, use a dry, clean microfiber cloth to hand wipe the surface clean of the cutting grade polish.

1. Apply sparingly. Polish with cotton flannel pad and random orbital buffer (1600-2000 rpm).

2. Polish until oxidation and residue disappear, about 60 seconds.

3. THE SHOULDER ZONE: Beginning top right or left of target polish area*, work back & forth, right to left within the targeted polish area. Then work same area up and down.

4. Light, but firm pressure is all that’s needed. DO NOT PRESS HARD AGAINST THE SURFACE.

5. On horizontal surfaces, pressure should be about the weight of the buffer.

6. Black residue will form over the 18”-24” target polish area. Continue moving the buffer back and forth/up and down across the surface for about 30-45 seconds. The black residue will begin to lighten and disappear.

7. Keep moving over the target polish area until black residue is gone and the clean aluminum surface shows.

Black residue may remain around the edges of the buffed area, but will be cleared as adjoining areas are buffed.

8. If there is cloudiness or scratches remain, repeat above steps until the surface is clear.

9. Repeat the above steps with each adjoining area.

10. When the wool compounding pad looks shiny with polish, fluff the nap by “spurring” with a buffing spur or a screwdriver blade held vertical against the face of the spinning pad.

11. Final finish with NuShine® IIS